| PilotOdyssey.com http://pilotodyssey.com/PO/ |
|
| sealing intake mating surfaces http://pilotodyssey.com/PO/viewtopic.php?f=1&t=1870 |
Page 1 of 1 |
| Author: | cshelden [ Sat Jan 14, 2006 7:37 pm ] |
| Post subject: | sealing intake mating surfaces |
I finished putting the 350 togather this afternoon. I did a preasure test and it has a slow leak on the intake manifold/reed cage surfaces. Can I use yahmabond here? I'll lap the aluminum to insure flat surface as well, but just wondering what I can use to seal that area better. I do have gaskets (new) installed. Other than that, I can't find any other leaks. Charlie |
|
| Author: | hoser [ Sat Jan 14, 2006 8:24 pm ] |
| Post subject: | Re: sealing intake mating surfaces |
cshelden wrote: I finished putting the 350 togather this afternoon. I did a preasure test and it has a slow leak on the intake manifold/reed cage surfaces. Can I use yahmabond here? I'll lap the aluminum to insure flat surface as well, but just wondering what I can use to seal that area better. I do have gaskets (new) installed. Other than that, I can't find any other leaks.
Charlie Yeah I have same problem on the Pilot I use a little yamabond on the gaskets.. don't over tighten them bolts |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|