Finally back on my FL400 project (life got in the way for a while...). Was wondering if anyone might be able to help me out with a couple of pictures of the wire routing on the recoil starter side of the Engine? I have the manual, and can see how the fuel sensor wires are routed, but don’t see how to get the others coming out of the Engine case to where they need to go. Have searched this sight and haven’t been able to find it. Thanks in advance for any help. Also, if Hoser sees this picture- yes, you built this engine- and I hope to hear it running in a couple of weeks! Thanks again.

All those go down to the frame where the motor (( Internal Combustion Engine ? )) mounts are and run above the frame as to not get skid damage then over to the rectifier where they then plug in to the rest of the harness. This includes the rectifier and CDI (Capacitor Discharge Ignition) coils. Also the Engine ground wire runs in parallel to the same frame rail. The only exception are the two female spade connectors which attach to the fuel tank reserve sensor.

Thank you!