Rppjr wrote:
Dang, that’s a first for me ever seeing. Every last part, that’s awesome!!!
Not every last one is new but as close as I could get, these are the parts I had to use that were not new but they were mint used, starter, both starter gears, pinion gear, balance drive gear and flywheel. I found a new flywheel but $1200.00 was just to much and it was flywheel only no stator combo.
liduno wrote:
Why do you think you shouldn't have done it? I mean who doesn't want a brand new Engine?
The cost of all the discontinued and rare parts was huge, I would tell you what I have in this but then you would not think I am nuts, you would know it. Haha, for sure you would know it and I felt like I got good prices on things until I added it all up.
adnoh wrote:
Oh my eye candy that is just cool as heck. Lucky Man. Nuts? no way put that in a trailer queen chassis and put it on display in your living room. Set in it and watch football and have Wife bring snacks and favorite cold ones. On second thought you would not want to get it dirty.Nice job.
Yes Sir, you can see where all those parts were laid out, in my living room. My wife is the best.
I have thought about just putting it on the shelf and looking at it, there are other engines out there to be ran, this one can stay new as far as I am concerned. I will admit that I have thought about putting it in a chassis just to see what it will do, I have a new set of CR250 reeds, a Danifold that I got from him before Lee started making them. I have 3 domes for the head (one is on loan and has to be returned once I figure out which one I am going to use), 49, 50 and a 51cc, I still need to check squish, ring end gap, I have a new take off exhaust manifold that I need to match to the cylinder, the cylinder is a PT high rev cylinder. I have a second Paul Turner pipe that I could run on it as well but I sure do like it being all new and pretty.
adnoh wrote:
Man I hate to ask just would like to know. What is the thrust (between crank and case)number for clutch side and mag side. Can you softly measure it with a set of feller gauges and let me know. Pretty please.
I sure will but it could be a little while, I have my roof being completely redone and one of the guys put his foot through the ceiling in my work room so I have everything moved out until they get it fixed.