PilotOdyssey.com
http://pilotodyssey.com/PO/

Comet Duster Clutch and Driven Help
http://pilotodyssey.com/PO/viewtopic.php?f=28&t=19693		 Page 1 of 1
Author:  Morecubes Mike [ Tue Feb 18, 2020 7:09 am ]
Post subject:  Comet Duster Clutch and Driven Help
So I bought a FL250 and it wants to drive even at idle. I thought the belt was wrong as it seems too wide for the driven pulleys but turns out I have a duster clutch ch which needs the wide belt. So Amongst the pile of parts that came with it is a driven pulley that’s smaller in diameter and is wider so I’m thinking this is the pulley that should be used with the duster clutch. I’m looking for conformation before I spend and time cleaning it up and fitting it, possible it is damaged and was swapped out for that reason
Attachment:
D8AEC7E1-C379-46A3-AC3E-C8B01D90019B.jpeg
D8AEC7E1-C379-46A3-AC3E-C8B01D90019B.jpeg [ 73.62 KiB | Viewed 23417 times ]


Attachments:
5AFAE43B-A8BF-4F3A-B22D-91F667376B1B.jpeg
5AFAE43B-A8BF-4F3A-B22D-91F667376B1B.jpeg [ 69.31 KiB | Viewed 23417 times ]
112362A2-BD3C-4A7C-8BF7-AFE579900DAB.jpeg
112362A2-BD3C-4A7C-8BF7-AFE579900DAB.jpeg [ 64.13 KiB | Viewed 23417 times ]
Author:  Morecubes Mike [ Tue Feb 18, 2020 9:31 pm ]
Post subject:  Re: Comet Duster Clutch and Driven Help
Can someone with a duster setup measure there driven pulley diameter so I can compare to the pulley I have sitting here
Author:  fully [ Wed Feb 19, 2020 11:10 pm ]
Post subject:  Re: Comet Duster Clutch and Driven Help
that belt looks to wide, it should fit flush with the driven clutch
Author:  Morecubes Mike [ Thu Feb 20, 2020 9:03 am ]
Post subject:  Re: Comet Duster Clutch and Driven Help
That’s because it’s the wrong driven pulley I’m trying to find info on what I should be running
Author:  canadian oddy [ Tue Feb 25, 2020 2:58 pm ]
Post subject:  Re: Comet Duster Clutch and Driven Help
Morecubes Mike wrote:
That’s because it’s the wrong driven pulley I’m trying to find info on what I should be running


I don't know if this will help you, but on an oddy FL350 the driven pulley is 8 1/2" in diameter.
The stock FL350 driven is a 90D Salsbury.
I see that you have an FL250 but all my machines are FL350's. Hope this helps.
CO
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/