PilotOdyssey.com http://pilotodyssey.com/PO/ |
|
How to Space Rear Driven in FL250 to Use Larger Sled Belt? http://pilotodyssey.com/PO/viewtopic.php?f=28&t=8289 |
Page 1 of 1 |
Author: | bighead [ Sun Nov 07, 2010 8:49 pm ] |
Post subject: | How to Space Rear Driven in FL250 to Use Larger Sled Belt? |
This may be a dumb question but I have never had one of these driven clutches apart. I need to add a spacer to take the larger sled Engine belt. My questions are. 1. Is the spring loaded? 2. What type of puller? 3. Do I need a puller for the pully part of the clutch as well as the front? And if so are they the same pullers? 4. What size spacer for the belt? I think 1 1/4 belt. 5. If I add a spacer will the snap ring still line up on the end of the shaft? Is there two slots? It seems I read there was two slots. 6. Any mods I can do to the driven now that will better for the 340 sled motor (( Internal Combustion Engine ? ))? My project is a 1983 Fl250 and I swapped a 340 yamaha sled motor (( Internal Combustion Engine ? )). Any tips info or what to expect would be really cool. Or any threads on this topic? I cannot seem to find any just members talking about adding spacers when doing this same swap. |
Author: | SRX 540 [ Mon Apr 09, 2012 12:10 pm ] |
Post subject: | Re: How to Space Rear Driven in FL250 to Use Larger Sled Bel |
Just put a spacer in between the clutch halves that's about 3/16 of an inch thick. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |