PilotOdyssey.com http://pilotodyssey.com/PO/ |
|
Fl250 CDI (Capacitor Discharge Ignition) terminal for diy wiring harness http://pilotodyssey.com/PO/viewtopic.php?f=63&t=15821 |
Page 1 of 1 |
Author: | karmatib [ Thu Jul 09, 2015 4:41 pm ] | ||
Post subject: | Fl250 CDI (Capacitor Discharge Ignition) terminal for diy wiring harness | ||
I apologize if this is already known but I couldn't find anything. I wanted to run all new wires on my fl250 build and I needed the end that plugs into the CDI (Capacitor Discharge Ignition) box.(I upgraded from points so my stock harness doesn't have the plug.) It took me a while but I got the correct plug and pins. I hope this helps people with the points to CDI (Capacitor Discharge Ignition) conversion. http://cycleterminal.com Has them for cheap. 6 pin 2.8mm - .110 Male and Female locking connector - Nylon Connector with Terminals Terminals Fit wire size .6 - 1.3 mm (16-22 AWG) Natural Connector Set Male and Female - Set SC1106 Nt $3.00 each Black Connector Set Male and Female - Set SC1106 Blk $3.05 each
|
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |