| PilotOdyssey.com http://pilotodyssey.com/PO/ |
|
| Recoil Modification http://pilotodyssey.com/PO/viewtopic.php?f=72&t=812 |
Page 1 of 1 |
| Author: | hoser [ Sun Sep 05, 2004 5:44 pm ] | ||
| Post subject: | Recoil Modification | ||
The recoil that came with my 440 Engine is from a snowmobile Engine for the most part under the hood of a sled is pretty clean, keeping sand mud and dirt out is not a issue, I welded on a short stub of pipe onto the recoil housing so I could slide a heater hose over it to seal it up some.
|
|||
| Author: | hoser [ Sun Sep 05, 2004 5:46 pm ] | ||
| Post subject: | |||
I took another piece of pipe and welded it to flat stock and bolted it to the frame, another short piece of heater hose goes between the tube and the recoil handel
|
|||
| Author: | hoser [ Sun Sep 05, 2004 5:47 pm ] | ||
| Post subject: | |||
Finish product, pretty well sealed now...
|
|||
| Author: | Drakman [ Sun Sep 05, 2004 6:23 pm ] |
| Post subject: | |
Looks good, does it have electric start also? |
|
| Author: | litespeed [ Sun Sep 05, 2004 6:24 pm ] |
| Post subject: | |
How's it start? Lot of power needed to pull it? The Drak is hard to when you first pull on it I guess from initial compression but then it eases up a little. |
|
| Author: | hoser [ Sun Sep 05, 2004 6:48 pm ] |
| Post subject: | |
No E start pull only, I don't think it is hard to pull, still don't have the cold starting figured out yet, gotta rig up the choke cable and learn to start it... Had it down to 2-3 pulls when cold then messed with the pipe and carb so it is gone hehe starts with a 1/2 pull when Engine is warm. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|