4X4 Tuff torque pipe with Super Silencer

The installation is pretty straight forward and just like installing any other after market 
exhaust pipe the brackets are close but not exact some might need a little bending 
to make a good fit, this dont suprise me at all the pipe was made then shipped to 
another company to be creamic coated then shipped out to me so the brackets 
are bound to get tweaked a bit in the handling, it is really no big deal just a minor 
adjustment here and there.

When you get the pipe installed it is important to make sure that the pipe or 
brackets are not touching the frame, if it does touch the vibration will crack 
the pipe mounts.

You really need to play attention on this mount, I have seen 3 break at the frame,
make sure that there is plenty of clearance, I added a flat washer between the rubber 
mount and the pipe bracket to allow for extra movement you might see when the engine
is at full power or torque.


I use High Temp Silicone sealant on this connection and let it dry 24 hours before 
starting the engine, some people like to use a high temp rubber hose and hose 
clamps.

The top bolt you see on this bracket is a 1/4" bolt with a flat washer on each 
side.


Over all the installiation went smooth and only took about 45 minutes to install
the fit was about the same as installing my ATV Racing Rev pipe and Quiet Silencer.